Manométer / szenzor csatlakozók, mérőpontok, mérővezetékek (Minimess)

STANDARD "MINIMESS" FLEXIBLE MEASUREMENT LINES

- Flexible, steel spiral reinforced plastic hose for transferring pressure signals, usually between measurement points and gauges
- Internal diameter: 1.8 mm
- Both ends are rotating hollander-type connections with internal M16 x 2 threads
- Max. nominal pressure: 630 bar
- Temperature range: -50 - +140 Celsius

MEASUREMENT POINTS (FOR SCREWING INTO INTERNAL THREADS)

- Screw-in measurement points
- Standard 16x2 Minimess thread with checkvalve and sealed dust protection cap
- Max. nominal pressure: 630 bar

Tube to tube fittings with measurement point

- To be used in DIN steel hydraulic pipelines. Sealing by nut and ring.
- Nuts and rings included, 2pcs of each.
- Standard 16x2 Minimess thread with checkvalve and sealed dust protection cap
- Selection based on DIN or GAZ pipe (outside) diameters

S: DIN "heavy series" ; L: DIN "light series"

Measurement point for end of steel pipeline

- Mounting on end of steel hydraulic pipeline
- To mount, use a standard pipe union with nut and ring.
- Standard 16x2 Minimess thread with checkvalve and sealed dust protection cap
- Selection based on DIN or GAZ pipe (outside) diameters

Standard pressure gauge fittings 16 X 2 (SCHOTT-fitting)

- For connecting the Minimess hose to a pressure gauge
- With the hex nut, mounting the pressure gauge to a bulkhead is possible
- Internal thread on the manometer side, 16x2 external thread connection for the Minimess measurement hose

Pressure gauge direct fittings for end of steel pipeline

- Mounting a pressure gauge directly on the end of steel hydraulic pipeline
- Selection based on DIN, GAZ or French series pipe (outside) diameters, associated with the standard threads and cones

Quick coupling-type / special measurment connectors

- These connector assemblies let the tecnician connect gauges to quick couplings or special measurement points using a standard Minimess hose.
- Selection is based on the special side of the assembly. Other side always ends in a Minimess 16x2 standard measurement point with cap, to connect the standard hose.

 WR8
 ISO-A
 JCB

 CAT, Case, Claas, JD, etc. straight & elbow

 Komatsu CEJN

Measurement hose adaptors

- Adaptation between measurement hose and measurement point

Direct connector for sensors and manometers

- For use on external threaded pressure or temperature sensors, or manometers. The other end is standard Minimess 16x2 outer thread.
- By mounting the direct connector on the measurement device, it enables the device to be used directly on an existing standard measurement point without disassembling the line.

Measurement hose extension

- Connectors with the same ports on both ends to extend measurement hoses.